|
|
BabyHopes™ One-Step LH Ovulation Test Instructions
How The Test Works
The BabyHopes On-Step Ovulation Test will help you find the time when you are most able to become pregnant. Luteinizing hormone is always present in human urine. LH increases dramatically just before women's most fertile day of the month in a process commonly referred to as the "LH Surge" This LH increase triggers ovulation, which means an egg is released from woman's ovary. Because the egg can be fertilized only 6 to 24 hours after ovulation, detecting ovulation in advance by testing for the LH surge is very important for women seeking pregnancy.
The best times to test are between 11am and 3pm and 5pm and 10pm. If you want to make sure that you catch your surge, you may want to test twice a day, once in the earlier time frame and the other in the later time frame. Please keep in mind that while you may have the initial surge of LH earlier in the day if testing via blood tests, you will not get a positive result on the ovulation test until 4-5 hours later when the surge actually reaches your urine.
Before You Begin
- Do not open the foil packet until you are ready to perform the test.
- Do not use the BabyHopes LH One-Step Ovulation Test beyond the expiration date printed on the package.
- Store tests at room temperature (below 86 degrees F). Do not freeze.
- Early morning testing is not recommended as most women experience a blood LH surge but it does not show up in the urine until later in the day.
- The best times to test are between 11am and 3pm and 5pm and 10pm.
- Some women have found that their best sample is after 12 noon.
- Test at the same time each day.
- Reduce your liquid intake for 2 hours before testing, since drinking excessive amounts of liquids can dilute the LH in your urine.
- Select a well-lit room with a clean, flat surface for performing the test.
When to Begin Testing
To find out when to begin testing, determine the length of your normal cycle. The length of your cycle is from the beginning of one period (the day of first bleeding) to the day before the beginning of the next. Count the first day of bleeding or spotting as day one (1). If your cycle length is irregular, that is, if it varies by more than a few days each month take the average number of days for the last 3 months. Use the chart shown to work out the day you should begin testing. The day you begin testing is posted opposite the number of days in your normal cycle.
|
Length of
Normal Cycle
(Total days)
|
Start testing
this many days after your last period began
|
|
Length of
Normal Cycle
(Total days)
|
Start testing
this many days after your last period began
|
|
21
|
5
|
|
31
|
14
|
|
22
|
5
|
|
32
|
15
|
|
23
|
6
|
|
33
|
16
|
|
24
|
7
|
|
34
|
17
|
|
25
|
8
|
|
35
|
18
|
|
26
|
9
|
|
36
|
19
|
|
27
|
10
|
|
37
|
20
|
|
28
|
11
|
|
38
|
21
|
|
29
|
12
|
|
39
|
22
|
|
30
|
13
|
|
40
|
23
|
For Example:
If your period normally begins every 28 days, you should begin testing
eleven (11) days after the beginning of your last period.
The calendar below illustrates that if the ninth (9th) is the first day of your
menstrual bleeding, then the 19th, or day eleven (11), of your cylce is the
day to begin testing.
|
SUN
|
MON
|
TUE
|
WED
|
THUR
|
FRI
|
SAT
|
|
1
|
2
|
3
|
4
|
5
|
6
|
7
|
|
8
|
9
|
10
|
11
|
12
|
13
|
14
|
|
15
|
16
|
17
|
18
|
19
START
|
20
|
21
|
|
22
|
23
|
24
|
25
|
26
|
27
|
28
|
|
29
|
30
|
31
|
|
|
|
|
Instructions
Bring the test pouch to room temperature (18-30 degrees C). Collect urine into a clean container (such as plastic cup). The best way to collect sample is by placing a cup in the middle of urination process. To begin testing, open the sealed pouch by tearing along the notch. Remove the test from the pouch when you are ready to use it.
- Immerse the strip into the urine with the arrow end pointing toward the urine. Do not immerse past the MAX (maximum) line. Take the strip out after 7 - 10 seconds and lay the strip flat on a clean, dry, non-absorbent surface (e.g., mouth of the urine container). You will see the urine start travelling up under the tip of the test.
- Wait for colored bands to appear. Depending on the concentration of LH in the test specimen, positive results may be observed in as little as 40 seconds. However, to confirm negative results, the complete reaction time of 10 minutes is required. Do not read results after more than 30 minutes.
- After interpreting the test results, discard the test strip.
|
|
 |
Interpretation of the Test
As the LH One Step Ovulation Test Strip begins to work, a colored band will appear in the upper section of the result area to show that the test is working properly. This band is the Control Band (C). The lower section of the result area indicates the test results. If another colored band, the Test Band (T), appears at the lower section of the result area and is of equal or darker color than the Control Band, the results should be interpreted as a positive test.
Positive Result
If two color bands are visible and the test band is equal to or darker than the control band, one will probably ovulate in the next 24-48 hours. If one wants to be pregnant, the best time to have intercourse is after 24 hours but before 48 hours.
Negative Result
Only one color band appears on the control region or the test band is present but lighter in color intensity than the control band. There is no LH surge even if two lines present - as long as test line is fainter than the control line the result is negative.
Invalid Result
No visible bands in the control and test regions. Make sure to follow the above specified instructions for optimum results. You have to repeat the test by using a new LH One-Step Ovulation Test Strip.
|
|
|
When to Stop Testing:
Unless otherwise specified by your doctor, stop testing once the LH surge is detected.
Limitations of the Test
- For single in vitro diagnostic use only - use test only once for urine screening.
- Do not use test kit beyond expiry date.
- The test works only if the instructions are followed precisely. Although the LH One-Step Ovulation Test Strip is highly accurate and sensitive in detecting ovulation, an extremely low incidence of false results (positive when no ovulation exists or negative when ovulation exists) can occur.
- The LH One-Step Ovulation Test Strip should not be used for contraception.
- Some prescription drugs, such as menotropins may affect the test result. Certain rare medical conditions or the onset of menopause can cause elevated levels of LH. Some women do not ovulate every cycle and they will not see any increase in the level of LH hormone during these non-ovulating cycles. Women with Poly Cystic Ovary Syndrome (PCOS) may not get reliable results from ovulation tests. Please check with your doctor if you are unsure.
|
